Investigate distribution of stomata and guard cells
Counting stomata
Scientists use sampling and counting techniques to investigate the distribution of Tiny holes in the epidermis (skin) of a leaf. They control gas exchange by opening and closing and are involved in loss of water from leaves. Singular is stoma. on leaves. They count stomata to investigate:
- their numbers, density and distribution on upper and lower surfaces
- numbers that are open and closed at any time
- adaptations of plants to environmental conditions, eg desert and water plants
- effects of changing conditions such as increased carbon dioxide concentrations from climate change
Below are two methods with which stomata can be counted.
Method 1
- Put a small drop of water on a microscope slide.
- Hold the leaf with the surface you want to examine uppermost.
- Tear the leaf at an angle so as to reveal part of the epidermis.
- Place the leaf on the microscope slide and examine.
Method 2
- Paint the surface of the leaf with clear nail varnish.
- Allow to dry.
- Peel off the nail varnish with forceps.
- Place on a dry microscope slide and examine
Recording the distribution
The density of stomata on a leaf is recorded per unit area, usually the number per sq mm.
A microscope is To set an instrument or scale against a standard. so that its The area seen when looking through a microscope. is known.
Calculating the area
In the illustration, the diameter of the field of view of the microscope is 0.40 mm.
Its area can be calculated using formula \( \pi {r}^{2} \)
Where \( \pi = 3.14\)
\(r\) = radius of the field of view
If the diameter of the field of view is 0.40 mm, the radius is 0.20 mm.
\( Area = \pi {r}^{2} = 3.14 \times 0.20 \times 0.20 = 0.13~mm^{2}\)
The number of stomata in the field of view is 12.
The area of the field of view is 0.13 mm2.
Therefore, based on this single count, the density of stomata over 1 mm2 is:
\(12 \times \frac{1.00}{0.13} = 92~stomata\)
The density of stomata is therefore 92 stomata per mm2.
Question
Using the same microscope, what is the density of stomata per mm2 based on the following counts?
24 23 22 27 28 25 26 24 26 25
192 stomata/mm2.
The average count = \( \frac{24+23+22+27+28+25+26+24+26+25}{10} = \frac{250}{10} = 25\)
The mean count = 25.
The field of view is 0.13 mm2.
Therefore, the number of stomata over 1 mm2 = \( (25 \times \frac{1}{0.13} = 192)\)
The density of stomata is 192 per mm2.
